Built in
The shown layout is based on a RG 15 wing with 200 mm width and 1 mm sandwich.
The torque rod should be placed as close as possible to the pivot point.
Illustrated in the drawing above with the dimension <1mm.
The pocket width should be 4.6mm in 20.5 mm distance to the pivot point.
The bend of the torque rod should be placed over the pivot point. The pivot point is the red line in the drawing above.
The RDSwiss pocket has 2 plates. The edge of the plates must be placed inline with the pivot point then good function is guaranteed.
The pocket has to be grinded and then fixed by epoxi glue.
Dimensions coupling
Length: 18mm
dia: 9.5mm
Dimensions pocket
height: 4.6mm
total length: 20.5 mm
slot: 3 mm
weight: 5 gr
Dimensions torque rod
Angle for flaps: 60°
Angle for ailerons: 35°
Please select for ordering.
(remark: in the sketch above this angle is 45°)
dia (D): 3mm
standard length: 27mm (straight rod length)
Notice: extra length of torque rod can be provided (for the same price)
How to define the extra length:
cut out the template and lay it on the wing (as in the installation movie).
Is the length on the template not long enough, measure the length between template position and
best positon of the servo. This distance gives the extra length. Please notice on order !